SBC 1000/2000 4.1.x : Configuring the System Clock Source

It is important that timing be consistent between elements of a VoIP topology. Sourcing the Sonus SBC 1000/2000 clock is critical in keeping the Sonus SBC 1000/2000 synchronized with other elements of the topology. The Sonus SBC 1000/2000 may obtain it's clock from a network (T1/E1) source such as a PBX or Central Office, or it may use its own internal clock which may itself by synchronized to an NTP source. Where the clock source originates depends entirely on the topology itself and varies on a case-by-case basis.

Configuring System Timing

To configure system timing using a network clock source:
  1. In the WebUI, click the Settings tab.
  2. In the left navigation pane, go to System > System Timing.

Configuration - Field Definitions

Clock Source

Specifies the source of the systems transmit clock.

Primary Clock Port

Specifies the DS1 port from which the clock will be derived. This field is visible only if Network is specified as the Clock Source.

Secondary Clock Port

Specifies the DS1 port from which the clock will be derived. This field is visible only if Network is specified as the Clock Source.
The Secondary Clock Source is used only if the primary clock source is not of sufficient quality or becomes unavailable.